GeoDesy Pronto X Series User Manual
Page 17
GeoDesy Kft.
17
E-mail: [email protected]
H-1116 Budapest, Kondorfa str. 6-8. Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
Alignment steps
1. using the crosshair align the units into a roughly aligned position. Please note
that the alignment scope will not be able to provide with a perfect alignment,
this will have to be done using the fine alignment screws referring to the
received level screen on the LCD panel.
2. using the fine adjustment screws on the alignment base set the units to the
highest received level possible. (for further details on how to perform the fine
adjustment refer to 6.2.1 and 6.2.2 chapters)
Default distance setting of all
Pinto Next AF
laser heads for 750m. As you can
see in below sketch, “+25 STEP” equals ~ 2 cm larger laser beam over 100 meters.
For example, if you would like to install the laser heads over 350 meters than you
will need smaller beam size to reach bigger distance (compared to the default
750m), so click on “-100 STEP” which will make the laser beam narrower and will
be proper for 850m. While clicking on the “STEP” buttons please check the remote
received level on the laser head.
Please perform the same operation on the other side.
3. After we have got the proper level, please click on “Save position as default”
button. As you have clicked on the “Save position as default” button the laser
heads will enable the AUTO FOCUS mode (enabled). The equipment will
automatically improve the remote level to the most ideal position.