Barco R9002328 User Manual

Page 40

R5975059A BARCOVISION 708 200498

CONTROLLING

R5975059A BARCOVISION 708 200498

CONTROLLING

5-5

Projector address

a. hardware set up of the projector address.

Every projector requires an individual address between 0 and 16 which is set with

hardware DIP switches inside the projector. To change that address, contact a

BARCO authorized technician.

b. How to control the projector.

The projector's address may be set to any value between 0 and 16. When the address

is set, the projector can be controlled now with :

- the RCU for addresses between 0 and 9.

- computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between

0 and 16 (only when the optional RS232 communication port is installed)

Note : a projector will respond to an RCU set to an address of '0' regardless of what

address is set in the projector itself.

c. Using the RCU.

Before using the RCU, it is necessary to enter the projector address into the RCU (only

when that address is between 1 and 9). The projector with the corresponding

address will listen to that specific RCU.

When address 0, 'zero address' is programmed into the RCU, every projector, without

exception will listen to the commands given by this RCU.

How to display a projector address?

Press the ADDRESS key (recessed

key on the RCU) with a pencil.

The projector's address will be

displayed in a 'Text box'. This text

box disappears after a few sec-

onds.

To continue using your RCU, it is

necessary to enter an address

with the digit buttons (address be-

tween 0 and 9). For example : if the

Address key displays projector

address 003, the press "3" digit

button on the RCU to set the RCU's

address to match the projector's

address. Do not press digit 003.

This will address the remote to '0'

and control all projectors in the

room.

PROJECTOR

ADDRESS

001