Barco R9002328 - Manual (Page 31)

CONNECTIONS
CONNECTIONS
CONNECTIONS
CONNECTIONS
R5975059A BARCOVISION 708 200498 R5975059A BARCOVISION 708 200498 4-8 4-8
(to gain access to the local keypad, see Local keypad in chapter Location
and functions of control.)
- Press ADJUST key, the General access menu is displayed on the screen.
- Use the control disc to high-
light 4.
- Press ENTER to select the
highlighted source.
RGB3S or RG3sB input selection
a. Press digit button 4 on the RCU or
b. With the local keypad :
GENERAL ACCESS
Select with й , к
з or è
then
to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6
3 4
1 2
Enter ADJUST
Connecting a Component source.
(R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance
(Y) input. The projector detects automatically where the sync signal is located.
Line doubling is possible for component video input sources on standard line
frequency.
If a line doubler is built in :
the default position of this line doubler is ON (active), the component video
input signal will be displayed as a non interlaced image (= improved image
stability).
To enable or to disable this line doubler function, enter the adjustment mode
and change the position of the ON/OFF toggle switch (see Picture tuning in
chapter 'Guided' adjustment mode or 'Random access' adjustment mode).
(to gain access to the local keypad, see Local keypad in chapter Location
and functions of control.)
- Press ADJUST key, the General access menu is displayed on the screen.
- Use the control disc to high-
light 4.
- Press ENTER to select the
highlighted source.
RGB3S or RG3sB input selection
a. Press digit button 4 on the RCU or
b. With the local keypad :
GENERAL ACCESS
Select with й , к
з or è
then
to return
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
5 6
3 4
1 2
Enter ADJUST
Connecting a Component source.
(R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance
(Y) input. The projector detects automatically where the sync signal is located.
Line doubling is possible for component video input sources on standard line
frequency.
If a line doubler is built in :
the default position of this line doubler is ON (active), the component video
input signal will be displayed as a non interlaced image (= improved image
stability).
To enable or to disable this line doubler function, enter the adjustment mode
and change the position of the ON/OFF toggle switch (see Picture tuning in
chapter 'Guided' adjustment mode or 'Random access' adjustment mode).