beautypg.com

Service mode, Crt run in cycle – Barco R9002328 User Manual

Page 124

background image

R5975059A BARCOVISION 708 200498

SERVICE MODE

SERVICE

MODE

R5975059A BARCOVISION 708 200498

SERVICE MODE

SERVICE

MODE

9-19

9-19

Select with ê or é

then

to return.

CRT run in cycle

The CRT run in cycle option can only be activated when memory blocks on an

internal # pattern are available. When one or more such blocks are available, a

flashing white image (5sec on, 5 sec off) is generated and that for 5 min on the

first internal block. In the next 5 min, a second internal block will be used to generate

the flashing white image. The image will also be shifted in a vertical way to prevent

a CRT burn in. To quit the CRT run in cycle option, press EXIT.

Highlight 'CRT run in cycle' with

the control disc and press ENTER

to start.

If a memory block adjusted on an

internal # pattern is available, the

CRT run in cycle will start when

pressing ENTER. If no such a block

is available, the projector cannot

run the CRT run in option and leaves

the adjustment mode.

If you still want to run CRT run in

cycle, create first a memory block

on an internal # pattern and restart

the CRT run in option.

ENTER starts the 'CRT run in' when an

internal generated # pattern is available.

EXIT returns to the Path Selection main

menu.

ENTER selects the CRT run in cycle option.

EXIT returns to the Path Selection main

menu.

COMMON SETTINGS

G2 ADJUSTMENT

CRT RUN IN CYCLE

PROJECTOR WARM UP

CRT DRIVE MODE

A flashing white pattern

will be generated until

is pressed.

The projector only uses

memory blocks adjusted

on an internal # pattern;

if no such block is

available, the projector

can’t run the procedure

and leaves the adjustment

mode.

CRT RUN IN CYCLE

to continue

to cancel

Select with ê or é

then

to return.

CRT run in cycle

The CRT run in cycle option can only be activated when memory blocks on an

internal # pattern are available. When one or more such blocks are available, a

flashing white image (5sec on, 5 sec off) is generated and that for 5 min on the

first internal block. In the next 5 min, a second internal block will be used to generate

the flashing white image. The image will also be shifted in a vertical way to prevent

a CRT burn in. To quit the CRT run in cycle option, press EXIT.

Highlight 'CRT run in cycle' with

the control disc and press ENTER

to start.

If a memory block adjusted on an

internal # pattern is available, the

CRT run in cycle will start when

pressing ENTER. If no such a block

is available, the projector cannot

run the CRT run in option and leaves

the adjustment mode.

If you still want to run CRT run in

cycle, create first a memory block

on an internal # pattern and restart

the CRT run in option.

ENTER starts the 'CRT run in' when an

internal generated # pattern is available.

EXIT returns to the Path Selection main

menu.

ENTER selects the CRT run in cycle option.

EXIT returns to the Path Selection main

menu.

COMMON SETTINGS

G2 ADJUSTMENT

CRT RUN IN CYCLE

PROJECTOR WARM UP

CRT DRIVE MODE

A flashing white pattern

will be generated until

is pressed.

The projector only uses

memory blocks adjusted

on an internal # pattern;

if no such block is

available, the projector

can’t run the procedure

and leaves the adjustment

mode.

CRT RUN IN CYCLE

to continue

to cancel