COATS Kit 8560761701 Robo-Arm LR - Manual (Page 4)

4 • Tire Changers
11. Next, install the helper tool onto the extender
shaft using the roll pin.
Figure 11 - Install helper tool onto extender shaft.
12. Grease the steel ball and place it in the bottom
of the helper tool.
Figure 12 - Place greased ball in bottom of helper tool.
13. Install the helper tool on the cylinder shaft align-
ing it for set screw installation. Tighten the set screw.
Figure 13 - Install the helper tool on the cylinder shaft.
14. Connect 1/8-inch nylon tubes from robo cylinder
to cylinder arm valve fittings, as shown in figure 14.
Attach cable tie around tubes to bottom cylinder fitting.
Figure 14 - Connect nylon tubes.
15. Attach hose clamps to arms. Next, unwrap the
hose from valve, guide through hose clamps; and, with
the hose pushed over the barbed fitting, tighten hose
clamps by pulling clamp tabs off.
Figure 15 - Route hose and tighten hose clamps.
16. Next, reconnect the air pressure source and
check for leaks. Cycle the cylinder on the Robo-Arm™
LR several times to make sure cylinder operates cor-
rectly (valve up for cylinder up - valve down for cylinder
down).
Use Cable
Tie To Nest
Tubing
Nylon
Tube
Nylon
Tube
A
A
B
B
Route and
Connect Hose
C
C
Roll Pin
Set Screw