COATS HIT 6000 Truck Tire Changer - Manual (Page 6)

4 • COATS Heavy Duty Tire Changer
Electrical Installation
The H.I.T. 6000 requires 220 volt, 3 phase or optional
single phase power source. CAUTION: Only a licensed
electrician should install power source and hook up the
H.I.T. 6000.
Important: Installation of this unit in an area where
gasoline, gasoline fumes, or other flammable vapors are
present requires a motor/switch riser kit (PN 7120433)
to meet national electrical codes; including paragraphs
500-4, 501 (1-8), 511 (1-5), PP 70-377.
Disconnect power source and check with volt-ohm
meter to assure power is off before connecting wires
of machine.
CAUTION
Motor rotation must be clockwise looking
at top of motor. If counterclockwise, reverse
any two of the power wires.
Principal Operating Parts
Air Installation
A quick coupler is provided for disconnecting the air
supply during maintenance procedures. The male fitting
is on the inset hose. The female is in the parts bag for
installation on the owner’s air supply hose.
For lubrication of internal air system, a lubricator
should be installed in the air supply line.
General
The H.I.T. 6000 does not require bolting to the floor.
However, if desired, the two holes located at the
back of the machine, used for mounting on the pallet,
should be used. DO NOT BOLT AT THE FRONT OF THE
MACHINE.