COATS Kit 8114155 Serial Loader - Manual (Page 2)

Before you begin, be sure to download and upzip the
FMWLOAD software (available at the Hennessy
Service Center web site) onto your PC, or if available,
use the installation CD. You will use the FMWLOAD
software to load Balancer Upgrade files (Mxxxx.BL) to
the Serial Loader by the Flash Memory Card.
Note: Do not change any default parameters during
installation unless directed to do so.
Important! Do not connect the Serial Loader to the
PC before installing ALL of the required software.
Install FMWLOAD Software
1. Click START and then click RUN or, if available,
insert the installation CD and skip to step 3.
2. BROWSE to the FMWLOAD software location on
your hard drive: c:\Program Files\FMWLOAD. (The
example shows c:\Program Files as the location. Your
location may be different.) Double-click on the
SETUP.EXE file and then click OK.
3. When you see the “Welcome to the FMWload
Installation Wizard” screen, click NEXT.
4. When you see the following screen, click NEXT.
5. When you see the “Ready to Install the
Application” screen, click NEXT.
6. When you see the “FMWload has been success-
fully installed” screen, click FINISH. At the dialog box,
click YES to restart your computer.
Install USB Driver
7. After installing the FMWLOAD software, plug the
square connector on the USB cable into the USB con-
nector on the back of the Serial Loader. Then plug the
flat connector into the USB port on your computer or
self-powered USB hub.
If you are running Windows ® 2000…
8. A screen appears saying that your system has
detected new hardware. Then the Found New
Hardware Wizard screen appears. Click NEXT to con-
tinue.
9. Select the “Search for a suitable driver for my
device (recommended)” option, and then click NEXT.
10. Check only “Specify a location” then click NEXT
8114156 01 1/05 2 of 4
USB Square Connector USB Flat Connector