CHAMPION CG Manual - Manual (Page 10)

2
Installation
Installation
(continued)
Unpacking (continued)
6. Use 2 people to move the machine in order to install the legs.
7. Have 1 person behind the glasswasher tilt it back as the person in front twists the machine
to the right. This makes the front left leg mounting hole accessible.
8. Screw 1 of the legs tightly into place. Repeat this process for the remaining legs.
9. Lift the glasswasher off the pallet, and re-install the front door..
10. Level the glasswasher front-to-back and side-to-side by adjusting the leg bullet feet in or out.
11. Compare the site utilities with the data plate specifications. If they
agree, then proceed with the installation according to the diagrams on the next page.
12. Remove the packing material in the glasswasher and discard, then
remove any protective film on the machine.
Twist the
glasswasher
to the right,
then to the left.
TILT
6"-7½"
1½"
1"
Level front-to-back and side-to-side
Thread (1) leg in each
corner of the
machine base
Tilt the machine back to clear
plumbing connections.
Twist the machine to the right until the front right leg mounting
hole is accessible.
Make sure to install the legs tightly.