Pull-up speed control – BAND-IT S100 Classic Air Tool User Manual

Page 7

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P09287 rev. L

BAND-IT-IDEX, Inc. 2006

www.BAND-IT-IDEX.com

Page 7 of 18

S10099

Classic Air Tool

Pull-Up Speed
Control

PULL UP SPEED CALIBRATION

1. START WITH PISTON ROD IN FORWARD POSITION AND SET SCREW WITH JAM NUT ALL THE

WAY BACK (SCREW END FLUSH WITH BOSS). PUT SLOW / FAST SELECTOR ON “SLOW”.

2. SLOWLY PUSH VALVE HANDLE FORWARD UNTIL PISTON GLIDES BACK AND PRESSURE

INDICATES ON THE PRESSURE GAUGE.

3. KEEP HANDLE IN THAT POSITION AND TURN SCREW OUT UNTIL IT CONTACTS THE SURACE OF

THE SLOW / FAST SELECTOR. HOLD SCREW IN POSITION WITH HEX WRENCH AND TIGHTEN
JAM NUT.

4. CHECK CALIBRATION BY CYCLING TOOL ON BOTH SLOW AND FAST PULL UP. OBSERVE THE

DIFFERENCE IN PISTON SPEED.

FOR APPLYING MOST ALL BAND-IT PREFORMED CLAMPS, PULL SPEED CONTROL SHOULD BE IN “UP”
(FAST) POSITION.
CASES WHERE PULL SPEED CONTROL MAY BE USED IN “DOWN” (SLOW) POSITION ARE:

A) WHEN EXACT POSITIONING OF CLAMP IS REQUIRED.
B) FOR APPLYING CLAMPS TO LARGE OR HEAVY AND HARD TO HANDLE HOSE.
C) TRAINING A NEW OPERATOR.
D) IF CLAMPS ARE NOT PULLING SMOOTHLY.

SET SCREW

VALVE HANDLE

SLOW / FAST SELECTOR

PRESSURE GAUGE

JAM NUT

BOSS