BAND-IT BT1000 Boss Tool - Manual (Page 5)

BT1000
BOSS TM Tool
www.band-it-idex.com
Document # P98750 Rev. B
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved Page 5
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating Manual
BT1000 BOSS TM Tool Manual
Thank you for purchasing BAND-IT products.
Installation
Compressed Air
Joining required: quick
–disconnect coupling (female) for ¼” hose
Recommended air pressure: 95 PSI working 105 PSI max.
Maintenance
Depending on the working conditions and the use of the tool, the following
maintenance has to be made periodically:
1.
Air Unit:
•
Checking the air-pressure daily
•
Checking oil-level daily
•
The water separator must be emptied before it is full
•
The filter has to be cleaned
•
Check the function and proper adjustment of the lubricator daily (approximately
1-2 drops/min.)
2.
Cleaning:
If impact of dirt and dust is considerable, the feed wheel must be cleaned regularly
using a steel wire brush .
3. Lubrication
The worm gear is filled with MOLYKOTE BR 2 PLUS. Use the same type of grease
after repair.
When being exchanged, all valve parts and other movable parts have to be greased
with grease of type Mobilus EP2 or with equivalent product.
The diaphragm must always be rubbed with TALCUM before being installed.