BAND-IT BT1000 Boss Tool - Manual (Page 2)

BT1000
BOSS TM Tool
www.band-it-idex.com
Document # P98750 Rev. B
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved Page 2
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating Manual
Safety Guidelines
Read this manual to help understand the intent and operation of this tool prior to installing BAND-IT
clamps.
o Always wear safety glasses and appropriate gloves when operating this tool.
o Keep hands away from clamp while installing.
o Care should be taken to ensure fingers are not under the clamp being applied.
o Never use this product for anything other than its original intended purpose.
o Tool must be used by persons properly trained.
o Pay attention to the rules and regulations for preventions of accident which are valid for the
work place.
o Check tool regularly for broken or worn parts. Do not operate a tool with broken or worn parts.
o Never modify the tool. Modification can result in severe bodily injury.
IMPORTANT:
o
Always use the recommended clamping product with this tool.
o Always disconnect from air sources before performing any maintenance.
The BT1000 tool is to be used with BAND-IT ¾” (19 MM) Band and Seal only. Accordingly, BAND–IT–
IDEX, Inc. makes no representations with respect to the compatibility of this tool when used with non-
BAND-IT or any other incompatible product.