AirLive WLA-9000AP - Manual (Page 93)

5. Web Management 2: System Configuration and Status
AirLive WLA-9000AP User’s Manual 86
„ System Contact: Contact information for the system administrator responsible for
managing the WLA-9000AP. It is an alphanumeric string of up to 60 characters.
„ Community String For Read: If you intend the router to be managed from a remote
SNMP management station, you need to configure a read-only “community string” for
read-only operation. The community string is an alphanumeric string of up to 15
characters.
„
Community String For Write: For read-write operation, you need to configure a write
“community string”.
„
Assign a specific name and IP address for your SNMP trap manager:
A trap manager is a remote SNMP management station where special SNMP trap
messages are generated (by the router) and sent to in the network.
You can define trap managers in the system.
You can add a trap manager by entering a name, an IP address, followed by pressing
the ADD button.
You can delete a trap manager by selecting the corresponding entry and press the
DELETE SELECTED button.
To enable a trap manager, check the Enable box in the corresponding entry; to disable
it, un-check the Enable box.
5.1.6 Ping Watchdog
System Configuration -> Ping Watchdog
The Ping Watchdog will ping remote IP addresses to make sure the wireless connection is
active, if not, it can either reconnect or reboot. To prevent the AP from power recycling,
the PING watchdog will start 10 minutes after power up to prevent power recycle problem.