2 debugging commands – AirLive WLA-9000AP User Manual

Page 105

6. Command Line Interface

AirLive WLA-9000AP User’s Manual

BSSID Channel Signal Strength(dbm)
================================================
00-4F-69-52-A1-ED 36 -40
…

6.2 Debugging Commands

Those debugging commands are commands used for manufacturing testing process. If a

z_debug command looks similar to a Set command, please use the Set command instead.

z_debug http logout

Purpose: log out HTTP

Example:

Command> z_debug http logout

z_debug signature

Purpose: Enable or disable signature check on firmware

Example:

Command> z_debug signature disable

Are you sure ? ( y/n ) : y
Signature check is now DISABLED!!!

z_debug add ssid

Purpose: This command will replace the default ssid with the new one. It

will not add an additional SSID. We recommend to use the following

commands instead:

add ssid broadcast (enable/disable) to add a new SSID

set ssid to replace the current ssid name with a new one

Example:

Command> z_debug add ssid air1