AirLive WLA-9000AP - Manual (Page 89)

5. Web Management 2: System Configuration and Status
AirLive WLA-9000AP User’s Manual 82
requires you to manually enter the DNS Server addresses, you should enter them
here.
„ Click APPLY to go to the next screen.
Use DHCP Client Protocol to Get IP automatically
If you choose to use a DHCP Server to acquire an IP address for the WLA-9000AP
automatically, enable the check box “Use the DHCP client protocol to automatically get the
IP address for this device”. Then click “Next” to go to the next screen. As a reminder, you
might loss the IP address of WLA-9000AP when IP is assigned dynamically.
5.1.2 Time Settings
System Configuration ->Time Settings
It is important that you set the date and time for your WLA-9000AP so that the system log
will record the correct date and time information. We recommend you choose “Enable
NTP” so the time will be keep even after reboot. If your WLA-9000AP is not connected to
Internet, please enter the time manually. Please remember to select your local time zone
and click “Apply” to finish.
5.1.3 Password Settings
System Configuration ->Password Settings