2N PRI Gateways - User Manual - Manual (Page 90)

88
/n pr=prefix n=length of number (parameter /n is optional)
AT%N#2..7=pr/n,…
pr/n Next 7 list of prefixes dialed for ISDN
AT%N#9=net,max Net-network number, max-default length of number dialed from
ISDN
LCR
AT&R
Table of LCR
AT%R##=net,hh:mm/hh:mm/w*
,gr
Settings of line ## (0..63) of LCR table
net – number of Network list (0..8)
hh:mm/hh:mm/w* – time limitation for use this line
gr – GSM group numbers
Commands for Testing via AUX
AT!SPxx=dial
Initiates testing call from AUX interface (xx is the called interface):
1..15, 17-31 B-channel
32-rotaring B-channel
AT!SGxx=dial
Initiates testing call from AUX interface (xx is the called interface):
00..31 GSM module
32- to GSM via GSM module according to call prefix
AT!WPxx Connects the following call from interface xx to interface AUX.
1..15, 17-31 from B-channel no.
32 first incoming call from ISDN
AT!WGxx Connects the following call from interface xx to interface AUX.
00..31 from GSM no.
32 first incoming call from GSM
AT!D Terminates call on AUX interface
Commands for Tracing*
AT!RE
Start tracing of error messages active interface.
AT!Lx
Start tracing of LAN & Telnet on layer x
x=2 – Layers IP,TCP,Telnet
x=3 – Layers TCP, Telnet
x=4 – Layer Telnet
AT!Rx
Start tracing of ISDN PRI & GSM on layer x
x=1 – Layers 1,2,3,4
x=2 – Layers 2,3,4
x=3 – Layers 3,4
x=4 – Layer 4
AT!RR Start tracing (AT!R2) to COM1 interface
AT!RX
Stop tracing (AT!R2) to COM1 interface
* Tracing can run only via one port !!
Commands for sending and receiving SMS messages
AT!G=A6
Start low-level controlling for SMS messages (can run
only on one port)
AT!G=55 Stop low-level controlling on used port
Controlling SMS messages
AT^SX=ch
…(sms listing) request to list of all SMS messages and