Echo 77412 Owners Manual v.3 - Manual (Page 10)

Crary Bear Cat Owners Manual 8
Section
WARNING
Before inspecting or servicing any part of this machine, shut
off power source, disconnect spark plug wire from spark plug
and make sure all moving parts have come to a complete
stop.
If any bolts or nuts are dropped in the machine, be sure to
remove them before starting the machine. Remove items
from the shredder area by removing the discharge screen.
IMPORTANT
2
Assembly
2.1 ASSEMBLING THE HITCH, AXLE AND
WHEELS.
2.1.1 MODELS 77412, 77412S
When assembling the axles, the wheel base can be adjusted
from 36" to 46". Attach both axles to the hitch pole using
U-Bolts, 5/16" washers and 5/16" locknuts.
Slide a wheel onto the axle and secure with a 5/8" washer
and cotter pin. Repeat for the remaining wheel.
Position the trailer onto the axle using a hoist or jack:
3a. Standard Configuration (Figures 2.1 & 2.2): The axle
and wheels should be positioned at the end furthest
away from the engine. Secure the trailer to the hitch
pole using two 3/8" x 1" carriage bolts, 3/8" washers
and 3/8" nuts. The axle mounting brackets located on
each side of the trailer are already mounted in the correct
spot. Attach the axles to the axle brackets using U-bolts,
5/16" washers and 5/16" locknuts.
3b. Optional Configuration (Figure 2.3): Move the axle
mounting brackets on the side of the trailer to the holes
closest to the engine. The axle and wheels should be
positioned at the end closest to the engine. Secure
the trailer to the hitch pole using two 3/8" x 1" carriage
bolts, 3/8" washers and 3/8" nuts. Attach the axles to
the axle brackets using U-bolts, 5/16" washers and
5/16" locknuts.
Attach the hitch pole plate to the hitch pole using two 3/8" x
1" bolts, 3/8" washers and 3/8" nuts.
1.
2.
3.
4.
Figure 2.1 - Standard Trailer/Hitch Assembly
(Models 77412, 77412S)
Figure 2.2 - Standard Trailer Configuration
(Models 77412, 77412S)
Figure 2.3 - Optional Trailer Configuration
(Models 77412, 77412S)