BURY Time Suite - Manual (Page 30)

30
Configuring BURY Time Products
Factory reset
If you would like to use the BURY product in another vehicle and in so doing, assign it to another user,
then you have to reset the device to its factory settings. You also have to carry out this procedure if
you want to sell the product.
Select the corresponding product from the list and click on ‘re-set device’. If you confirm the two secu-
rity questions with a ‘yes’, all of the positional data on the product will be deleted. This can take a few
seconds depending on the amount of data. A message appears when this process is complete.
If a new user uses the BURY Time product with the same BURY Suite, you must delete the allocation
of the serial number of this device to an existing vehicle in the vehicle administration. To do this, click
on the corresponding vehicle and open the vehicle details. By clicking on the minus button, it is possi-
ble to delete the allocation and to restore the product to its factory settings.
Note:
During the deletion function, make sure that you do not remove the Micro-SD card from the X
card reader or the USB-plug of the adaptor cable from the PC or the device.
Firmware update
Every now and then, you can find notifications for updates to the BURY Times Suite and the Time
Products on the internet site www.bury.com. Inputting the previously saved data is then recommen-
ded before completing an update, if you want to be able to use new functions, for example. Please
don’t hesitate to call our hotline if you have additional questions about this topic.
A firmware update for the CC 9060 Time cannot be carried out via the BURY Time Suite. To do this,
please use the BURY Update Manager, which you can also find on the BURY internet site.