Advance Adapters 477023 User Manual
Page 12

(Step A-27)
(27) Install the transfer gear onto the output shaft. Use assem-
bly lube!
(Step A-24)
(24) Install the small ball bearing in the machined pocket on the
output shaft. Use a drop of assembly lube to hold it in place.
(Step A-25)
(25) Install the spacer onto the output shaft.
(Step A-26)
(26) Install the 2 caged needle roller bearings on the output
shaft. Use assembly lube.
(Step A-21)
(21) Notice that the cluster / counter gear does not incorporate
the stock sub-gear and spring washer. These are not used!
(Step A-22)
(22) Install the detent plugs (with Loctite 242), spring and ball
assembly on both sides of the assembly cases. This will
position the shift rails once the retaining plugs are in-
stalled. Torque the detent plugs to 9 ft./lbs. Use assembly
lube!
(Step A-28)
(28) Before proceeding, make sure you have installed these
snap rings!
(Step A-23)
(23) Apply a drop of assembly lube on the tip of the 4WD indicator
switch and install it into its original position on the reduction
case.