Snorkel TB65J - Manual (Page 68)

Chapter 11 – Troubleshooting
64 TB65J – 0084248
Symptom
All functions stop working.
Lower controls do
not work.
Upper controls do
not work.
Boom and drive functions seem
sluggish.
Turntable and main boom func-
tions do not work from the upper
controls.
Boom jerks while it is extending.
Tip boom extend/retract, jib, and
platform rotate functions do not
work from the upper controls.
Main boom drifts down.
Drive functions do
not work.
Continued on next page...
Possible Cause
Electrical system malfunction.
Battery disconnect switch turned off.
Emergency stop button at lower con-
trols is pushed in to the off position.
Controls switch is in the upper control
position.
Ground operation switch not held in
the on position.
Battery disconnect switch turned off.
Emergency stop button at lower and
upper controls is in the off position.
Control selector switch at lower con-
trols is in the lower control position.
Platform foot switch not engaged.
Hydraulic oil is cold and thick.
Boom speed knob set too slow.
Wire ropes are loose.
Boom speed knob set too slow.
The emergency lowering valve is
open.
Hydraulic system malfunction.
Load capacity exceeded.
Machine on too steep a grade.
Drive hubs are disengaged.
Corrective Action
Manually lower the boom using the
emergency lowering knob.
Place switch in the on position.
Pull the emergency stop button
outward.
Place the switch in the lower control
position.
Hold the ground operation switch in
the on position while operating the
control toggle switches.
Place switch in the on position.
Pull the emergency stop buttons
outward.
Place switch in the upper controls
position.
Step down on platform foot switch
while operating controls.
Use cold weather hydraulic oil as
recommended for weather condi-
tions. Warm oil before operating the
machine.
Turn knob toward fast.
Refer the problem to a qualified ser-
vice technician.
Turn knob toward fast.
Turn the emergency lowering knob
to close the valve.
Stow the machine and do not operate
until repairs are made.
Remove load from platform. Refer to
platform capacity placard for maxi-
mum capacity.
Lower the booms and drive to a level
surface.
Turn drive wheel disconnect plates
around so nipples point outward.