Snorkel S2633 - Manual (Page 51)

Chapter 12 – Troubleshooting
S2633 – 8210048 47
When a fault code is displayed on the upper control panel,
the chart below may be used to locate and eliminate situ-
ations where machine operation may be interrupted.
If the problem cannot be corrected with the action listed,
stow the machine and remove it from service. Repairs
must be made by qualifi ed maintenance personnel.
Fault Code Possible Cause Corrective Action
01 - 39 Upper or lower control function de-
pressed during machine start up.
From the upper controls make sure:
No selector buttons are de-
pressed.
The interlock switch is not de-
pressed.
The joystick is in neutral.
The steer switch is not de-
pressed.
From the lower controls make sure:
The enable button is not de-
pressed.
The platform raise/lower switch
is in the off position.
From the lower or upper controls:
Cycle machine power off then on
by pressing the emergency stop
button and then twisting the but-
ton clockwise to restore power.
y
y
y
y
y
y
y
Faulty lower or upper control panel
or machine error.
Stow the machine and do not oper-
ate until repairs are made.
54 - 67 Machine error. Stow the machine and do not oper-
ate until repairs are made.
68 Low battery voltage. Charge or replace the batteries.
Symptom Possible Cause Corrective Action
Battery charge indicator does
not indicate a reading when
charging batteries.
No source of power. Make sure power source is plugged in
and turned on.
Charger power fuse is blown. Stow the machine and do not operate until
repairs are made.
Hydraulic fl uid temperature of
160°F (71°C) or more.
Prolonged driving or platform opera-
tion.
Stop operation until fl uid cools.
High pressure fl uid return to reservoir
caused by kinked or twisted hose.
Remove the kink or twist from the hose.
Let fl uid cool before resuming operation.
Hydraulic system component failure. Stow the machine and do not operate until
repairs are made.
Severe hydraulic leak. Failure of hose, tube, fi tting, seal, etc. Stow the machine and do not operate until
repairs are made.