Snorkel S2633 - Manual (Page 46)

Chapter 10 – Stowing and Transporting
42 S2633 – 8210048
5. Use spreader bars of suffi cient length to keep the
chains, straps, or cables from contacting the scissors
structure or platform.
When using cables, use rigid corner protectors
at any point where the cable contacts on sharp
corners to prevent damaging the cable.
Careful rigging of the spreaders is required to
prevent machine damage.
6. Adjust the length of each chain or strap so the aerial
platform remains level when raised off the ground.
7. Use the hoist or crane to carefully raise and position
the aerial platform onto the transport vehicle.
y
y
Securing for Transport
Use the following procedure to secure the aerial platform
on the transport vehicle:
1. Chock the wheels.
2. Remove all personnel, tools, materials, or other loose
objects from the platform.
3. Properly stow the aerial platform.
4. Place the upper and lower emergency stop buttons
in the off position.
5. At the lower controls, turn the start switch to the off
position and remove the key.
6. Unplug the battery disconnect connector.
A
Caution
Ratchets, winches, and come-alongs may produce
enough force to damage machine components. Do
not over tighten the straps or chains when securing
the aerial platform to the transport vehicle.
7. Use chains or straps to securely fasten the aerial
platform to the transport vehicle using the front and
rear tie-down lugs as attachment points. Proper tie-
down and hauling is the responsibility of the carrier.