Snorkel X33RT-sn10000+ - Manual (Page 13)

1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and
debris), is level, and is capable of supporting the wheel loads.
2. Check clearances above, below, and to the sides of the platform.
3. Select DRIVE mode.
4. Engage the Interlock Switch and move the Control Handle to FORWARD or REVERSE to
travel in the desired direction. The speed of the machine will vary depending on how far from
centre the Control Handle is moved.
5. If the machine is not level the tilt alarm will sound, the lift enable light will not illuminate, and
the machine will not lift or drive. If the tilt alarm sounds the platform must be lowered and the
machine moved to a firm level surface before attempting to re-elevate the platform.
1. Select LIFT mode.
2. Check around the base of the platform to ensure that no one is in contact with the machine.
Engage the Interlock Switch and push forward on the Control Handle to lower the platform.
3. The platform will stop when it reaches approximately 1 metre from the stowed position and an
alarm will sound. Inspect around the machine to ensure no one is in contact with the machine.
After a pre-set delay continue to lower the platform as in step 2.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and
debris), is level, and is capable of supporting the loads.
2. Check clearances above, below, and to the sides of the platform.
3. Pull and hold the Stabiliser Switches backwards (one at a time) until all four stabilisers
contact the ground.
4. Visually check the level bubble to determine which stabilisers must be further extended to
level the platform.
5. When the Lift Indicator Light comes on the platform can be safely raised.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and
debris), is level, and is capable of supporting the wheel loads.
2. Check clearances above, below, and to the sides of the platform.
3. Press and hold the Auto Level Switch down to the auto level position until all movement stops
and the Lift Enable Light illuminates.
Operation Manual Page 9
Operation
T
RAVEL
W
ITH THE
P
LATFORM
E
LEVATED
NOTE: The ma chine will travel at re duced speed when the plat form is el e vated
L
OWERING THE
P
LATFORM
L
EVELLING THE
P
LATFORM
NOTE: The plat form can be lev elled ei ther man u ally or au to mat i cally by set ting the sta bi lis ers. It is
also pos si ble to use a com bi na tion of man ual levelling and auto lev el ling. For ex am ple the ma chine
can be man u ally lev elled part way and then "auto lev elled".
The en gine must be run ning and the ma chine set for plat form op er a tion.
L
EVELLING THE
P
LATFORM
M
ANUALLY
L
EVELLING THE
P
LATFORM
A
UTOMATICALLY