Snorkel X33RT-sn10000+ - Manual (Page 12)

1. Turn the key on at the ground control position.
2. Mount the platform and close the entry gate.
3. Turn the start switch to ON.
4. Depress and hold the COLD START button for approximately 5 seconds.
5. Turn the start switch to the start position.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps,
and debris), is level, and is capable of supporting the wheel loads.
2. Verify that the engine is started and the Chassis Emergency Stop Switch in ON (pulled out).
3. Mount the platform and properly close the entrance gate.
4. Check clearances above, below, and to the sides of the platform.
5. Pull the Platform Emergency Stop Switch out to the ON position.
6. Select DRIVE mode.
7. Engage the Interlock Switch and move the Control Handle FORWARD or REVERSE to
travel in the desired direction. the speed of the machine will vary depending how far from
centre the Control Handle is moved.
1. Turn the drive/Lift Switch to DRIVE
2. While engaging the Interlock Switch, push the Steering Switch to RIGHT or LEFT to turn the
wheels in the desired direction. Observe the tires while maneuvering the work platform to
ensure proper direction.
1. Select a firm, level surface.
2. Select LIFT mode.
3. While engaging the Interlock Switch, pull the Control Handle backward.
4. If the machine is not level the tilt alarm will sound, the lift enable light will not illuminate, and
the machine will not lift or drive.
5. If the tilt alarm sounds the platform must first be fully lowered, and either the machine
moved to more level ground or the stabilisers used to level the machine.
Page 8 Operation Manual
Operation
O
PERATION
Be fore op er at ing the work plat form, en sure that the Pre-Op er a tion Safety In spec tion has been
com pleted and that any de fi cien cies have been cor rected. Never op er ate a dam aged or mal -
func tion ing ma chine.
The op er a tor must be thor oughly trained on this ma chine.
S
TARTING THE
E
NGINE
T
RAVEL
W
ITH THE
P
LATFORM
L
OWERED
NOTE: Choose be tween hi speed drive (rab bit) and low speed (tur tle)
S
TEERING
NOTE: Steer ing is not self-cen ter ing. Wheels must be re turned to the straight ahead po si -
tion by op er at ing the Steer ing Switch.
E
LEVATING THE
P
LATFORM