Micropump GN Series Installation, Operation and Warranty Information - Manual (Page 7)

7
DOC No: 7046 REV G
Installation in Explosive and Fire Danger Zones
Micropump offers products designed and tested for installation in explosive or fire
danger zones. Contact your local Micropump distributor or contact Micropump directly
to determine if your product combination can be certified for this use.
In Addition to the warnings provided throughout this manual, the following must be
considered in any explosion or fire danger zone installation:
Ensure the pump head, motor, and any mounting adapter are suitable for
area classification.
Ensure that pumping liquid temperature is maintained within acceptable
range as specified by Micropump Certification of ATEX Conformity.
Neodymium Iron Boron hub magnets (Driving Magnet product codes N3
and N4) cannot be certified for use in potentially explosive atmospheres.
Leaking fluids may cause an unsafe condition. The product and system
piping should be inspected for leaks on a regular basis.