Micropump GN Series Installation, Operation and Warranty Information - Manual (Page 2)

2
DOC No: 7046 REV G
EC DECLARATION OF INCORPORATION
EC DECLARATION OF CONFORMITY
(Signature of Manufacturer)
Herewith we declare that the products described in this Installation,
Operation, and Warranty Handbook complies with the following provisions
applying to it:
Machinery Directive 2006/42/EC. Applied harmonized standards,
in particular:
EN 809:1998
ISO12100-1:2003 (replacing EN292-1:1991)
ISO12100-2:2003 (replacing EN292-2:1991)
EN14121-1:2007
ISO14847:1999
EN12162:2001
EN ISO 20361:2009
EN ISO 13732-1:2006
Manufacturer: Importer in country of use:
Micropump Vancouver
1402 NE 136
th Avenue
Vancouver, WA 98684
(Signature of Importer)
The machinery described in this certificate must not be put into service until the machinery in which it is
incorporated has been declared in conformity with the provisions of the Machinery Directive and their
amendments.
PUBLISHED BY
MICROPUMP INC.
A Unit of IDEX Corporation
March 2006 © Micropump Inc.
All rights reserved.
This manual contains proprietary information which is protected by copyright.
No part of this publication may be reproduced, transcribed, stored in a
retrieval system, translated into any language (including computer language),
or transmitted in any form without the written consent of the publisher. For
further information contact your local Micropump distributor. Every effort
has been made to ensure that the information contained in this manual is
accurate prior to printing. However, the products described in this manual are
subject to continuous development and improvement and Micropump shall
not be liable for any errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this
manual.