Apple Macintosh PowerBook 1400 - Manual (Page 113)

The modem didn’t dial the phone number.
m Check that the phone cord is plugged into the computer and into a working
phone line.
m Try dialing the number again. Sometimes there is a temporary connection
problem.
m Quit the program and restart it. Sometimes this procedure solves
temporary problems with the modem.
m Another program may be using the modem. Quit all other programs that
use the modem.
m Try using another communications program. If that works, the problem
may be in the Apple Remote Access software. Reinstall the software.
The modem dialed the phone number, but the connection failed.
m Check that the phone cord is plugged into the computer and into a working
phone line.
m Make sure your modem is plugged into an analog phone line. Do not use a
digital phone line. Digital phone lines can damage your modem.
m Check with your Apple Remote Access administrator to make sure your
version of Apple Remote Access is compatible with the version on the
computer you’re calling. If you’re using a version of Apple Remote Access
later than 1.0, you can use the Remote Access Setup control panel to set
your software to work with version 1.0.
I’m connected via Apple Remote Access but I can’t see any shared disks.
m Open the Chooser and click the AppleShare icon. Shared disks should
appear on the right side of the Chooser. If you still don’t see any shared
disks, and your Chooser has a box labeled Zones, choose a different zone
(some networks don’t have zones).
m If there are still no shared disks, or you can’t connect to the one you want,
contact your Apple Remote Access administrator or the owner of the
computer you want to connect to.
Whenever I try to use Apple Remote Access, a message says it’s not installed correctly.
m This message sometimes appears if AppleTalk is turned off. Make sure
AppleTalk is turned on in the Chooser.
113 Tips and Troubleshooting