Apple AppleShare IP 6.1 - Manual (Page 60)

60 Chapter 2
6 Click the Enable button.
When mail is enabled, the user can connect to this computer for mail service. The User
window shows the user’s mail account name below the Enable button.
7 Click Save.
Mail is set up for this user. He or she can configure and use any client e-mail application that
supports both the POP and IMAP protocols. For more information about these protocols or
other mail settings, see the Mail Server section of AppleShare IP Help after you complete the
remaining instructions in this manual.
8 If the Mail Server is not already running, choose Start Mail Server from the Mail Admin
program’s Server menu.
The Mail Server is now set up. Go to the next section to set up the Print Server.
Important Be sure to tell this user to enter this account name and the password you
assigned in the General panel when setting up his or her log-on information in a mail
application.
Important
If you install the AppleShare IP Mail Server on more than one computer (which
requires the purchase of an additional copy of AppleShare IP), you need to coordinate the
flow of mail among all of the computers that provide mail service. Depending on your
network configuration, you may also need to set up the Mail Server so that it forwards or
relays mail to other servers. Be sure to review mail service and mail forwarding in the Mail
Server section of AppleShare IP Help after you’ve completed this chapter. You should also
review your license agreement.