Apple Qmaster 3 - Manual (Page 66)

Remote Computer Address Dialog
This dialog is displayed when you click the Add/Remove button in the main Preferences
dialog. Use this dialog to enter IP addresses or ranges for remote computers.
• Host and “Host IP address range” buttons: These buttons control whether this dialog is
in IP Address mode (in which you enter a specific address) or IP Address Range mode
(in which you enter a range of addresses).
• Host: Use this mode to enter a host name and IP address for a specific remote
computer.
• Host IP address range: Use this mode to enter a name and set of range numbers
(Range From, Range To) for a range of remote IP addresses.
Setting Wide Area Network Preferences
Follow the instructions below to set wide area network preferences for
Apple Qadministrator.
To enter IP addresses or ranges for remote computers
1 Click Add (+).
The host address dialog appears.
2 In the host address dialog, do one of the following:
• Select Host, complete the Host Name and IP Address fields, and click Add Host.
• Select “Host IP address range,” complete the Range fields, and click Add Range.
66 Chapter 6 Administering Clusters