AEM Infinity Supported Applications - GM LSX 58X Engine - Manual (Page 6)

6
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest. Pin GM LS Hardware Specification Notes
C1-10 +12V_R8C_CPU
Battery Perm
Power
Battery Positiv e
Voltage
Dedicated power
management CPU
Full time battery power. MUST be
powered bef ore the ignition switch
input is triggered. (See C1-65.)
C1-11 Coil 4 Coil 4 IC 4 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-12 Coil 3 Coil 3 IC 3 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-13 Coil 2 Coil 2 IC 2 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-14 Coil 1 Coil 1 IC 1 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-15 Coil 6 Coil 6 IC 6 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-16 Coil 5 Coil 5 IC 5 Control 25 mA max source current
0–5V Falling edge f ire. DO NOT
connect directly to coil primary .
Must use an ignitor OR CDI that
accepts a FALLING edge f ire
signal.
C1-17 LowsideSwitch_2
Coolant Fan 1
Control
Cooling Fan Control
Lowside switch, 4A max,
NO internal f ly back diode. See "LowSide Assignment Tables"
f or output assignment.
C1-18 LowsideSwitch_3 MIL Output
Lowside switch, 4A max
with internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.
See Wizard page "LowSide
Assignment Tables" f or output
assignment.
MIL Activ ates when any of the
f ollowing f lags are true:
ErrorAirTemp, ErrorBaro,
ErrorCoolantTemp, ErrorEBP,
ErrorFuelPressure,
UEGO_0_Diag_error,
UEGO_1_Diag_error,
ErrorMAFAnalog, ErrorMAFDigital,
ErrorMAP, ErrorOilPressure,
ErrorThrottle.
C1-19 AGND_1 Sensor Ground
TP Sensor 1 Ground/
Engine Oil Pressure
Sensor Ground
Dedicated analog ground Analog 0–5V sensor ground