AEM 30-4900 Wideband Failsafe Gauge - Manual (Page 2)

Page 3
GETTING STARTED
THIS PRODUCT DOES NOT INCLUDE SOFTWARE IN THE PACKAGING. PLEASE DOWNLOAD
AND INSTALL THE WIDEBAND FAILSAFE CONFIGURATION SOFTWARE FROM THE AEM
WEBSITE AT:
www.aemelectronics.com/downloads
Alternatively, register on the AEM Electronics Forums at
http://forum.aempower.com/forum/index.php
Click on the All Software & Firmware Downloads forum. Click on the AEM Wideband Failsafe Software
link to reach the download page. The most recent software revision will be posted here as well as the link
above. Note that you can subscribe to this thread to be notified when software updates are released.
All
current software releases will include a set of revision notes describing feature changes or additions since
the last update.
Software Installation Instructions
Follow the Installation Instructions as outlined in the forum post described above. After the software
installation is complete, click on the AEM Wideband Failsafe icon (shown below) to launch the
application.
Connect the USB cable to the PC. The Wideband Failsafe will turn ON with ignition key-on power.
Alternatively, the Wideband Failsafe can be bench-programmed outside of the vehicle without powering it
by connecting just the USB cable. However, the UEGO sensor, MAP sensor, analog outputs, and CAN
outputs will not function.
Firmware Updates
To update the firmware, download the firmware file, if available, from
www.aemelectronics.com/downloads . While connected to the gauge with the USB cable, open the
AEM Wideband Failsafe Software. Go to the Tools drop down menu and select Update Firmware and
follow the on-screen instructions.