BNC 835 User Manual - Manual (Page 23)

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com
Figure 3-h CSV-file with four points (1
st
column: frequency in Hz, 2
nd
: power in dBm, 3
rd
: dwell
time in
µs, 4 th
: off time in
µs).NOTE: values must be separated by semicolon!
3.6.3.2 List Sweep Editor
The list sweep editor consists of a table editor on the right and the save and load functions on the left
(see Figure 3-i ).
To create a new list, just enter the various frequency and power values in line 1 to N. You can also
load an existing list sweep file (in CSV format) from the computer by using the Open list file button
below.
After you have completed the list sweep you can save the list either on your computer (Save list file
button) or load it to the instrument (  Send button). Once loaded to the instrument, the list is the
active list in the memory. To save the active list in the non-volatile memory of the instrument you enter
a filename and press the ↓Store button.
If you want to locally edit an already stored list, sweep from the instrument, select the respective list
sweep file (or memory) and press the  Get button.
The list sweep that shall be executed must be loaded into the Device list RAM by using the  Send or
↑Load buttons.
Confirm your selection with “OK” to return to the List Sweep Tab and start the sweep with ON/OFF
button.