Fast & Fluid Ferraris Automatic Mixer - Manual (Page 32)

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155432A-it,en,de.doc – 11/09/2006 32
Lubrication of the vertical guides, screws and shaft.
Advised lubricant products
Use a yellow adhesive generic grease for uncovered gears, gradation N.G.L.I. 2.
Preparation of the machine (first phase)
Switch on the machine with the door/shutter closed.
Close completely the cradle plates.
Open the door/shutter and switch off the machine.
Clean using a cloth the old lubricant and the possible residual paint
Greasing (first phase)
Grease the vertical guides using a brush.
Grease the plates command screws.
Grease the shaft
Preparation of the machine (second phase)
Close the door/shutter and switch on the machine
Open completely the cradle plates
Open the door/shutter and switch off the machine.
Now it is available the central part of the cradle that previously is covered by the guides.
Clean using a cloth the old lubricant and the residual paint
Greasing (second phase)
Repeat the greasing operation for the
part of the guides, screws and shaft
that now are discovered.
Alternative operation
It is possible to use spray grease too, but it has to be thick and adhesive