Fast & Fluid Ferraris Automatic Mixer - Manual (Page 27)

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155432A-it,en,de.doc – 11/09/2006 27
USE OF THE FERRARI MIXER
SWITCHING MIXER FERRARIS ON
Photo A
The door/shutter doesn’t open when the machine is switched off.
To switch the machine on turn in position “1” the main switch (positioned on the back
side of the machine). See photo A.. To lock the switch, a locker must be used.
Verify that the emergency push button is not pushed
OPENING DOOR/SHUTTER OPENING SHUTTER
Open the door/shutter
pulling the handle to the
right (as shown in the
figure)
Open the shutter pulling up
the handle (as shown in the
figure)
LOADING THE CAN IN THE MIXER
B C D
Open the door/shutter and press the lever
positioned below the inferior plate. See
photo B.
Extract the lower plate to facilitate
loading of heavier cans. See photo C.
Position the can on the inferior plate and
press again the lever to push the plate
back inside the machine (Push the inferior
plate until it locks inside the machine). See
photo D. Now close the door/shutter.
MIXING PAINT CANS
1) Set the desired mixing speed using the key
2) Start mixing cycle using or or (three preset times)