Fast & Fluid Ferraris Automatic Mixer - Manual (Page 23)

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155432A-it,en,de.doc – 11/09/2006 23
SAFETY SPECIFICATIONS
WORKING AREA
MAINTENANCE AREA
OPERATOR AREA
Compliance with security requirements
The machine must be used and serviced by trained personal only ,because it is possible that a wrong use can
introduce dangers and cause accidents.
The main areas in which can be present risks are:
Working area
Maintenance area
Power supply
220-240 VOLTAGE: The Ferraris Mixer must be connected to a voltage of 220 - 240 Volt (or otherwise specified following local
situations), which has a differential (MINIMUM 30mA), a magnetothermic protection of 16 Amp and a grounded outlet according
to local regulations.
115 VOLTAGE: The Ferraris Mixer must be connected to a voltage of 115 Volt (or otherwise specified following local situations),
which has a differential (MINIMUM 30mA), a magnetothermic protection of 25 Amp and a grounded outlet according to local
regulations.
THE ACCESS TO THE ELECTRICAL WIRING IS ALLOWED TO SKILLED PEOPLE ONLY.
DON’T WORK WITH THE MACHINE IF BACK PANEL IS OFF.
Safe use of the machine
The manufacturer has adopted all measures and attentions projecting, drawing manufacturing , checking , installing , starting and
defining the procedures for using its products, to guarantee the highest possible level during a rational use of the supplied
system. The components are in conformity to the recent security rules. Updated security equipments are installed to assure the
maximum security level that it is available today.
When using the FAST & FLUID MANAGEMENT Srl Ferraris Mixer, the following safety regulations need to be observed:
The "user" is expected to follow all local safety regulations. If there is a contradiction in European regulations and local
regulations, the demands of the most severe legislation must be met.
The installation and the maintenance of the Ferraris Mixer have to be performed by a specialized technician
Service safety rules
1. To prevent any physical injuries all outside panels should always be in place on the Ferraris Mixer and properly secured.
2. Don’t touch protections system as speed control and blocking security closing door/shutter.
3. Prior to any maintenance and inspection of the Ferraris Mixer: disconnect the power cord from the outlet mains. Make sure
that the Ferraris Mixer cannot be started unexpectedly.
4. Do not leave any tools inside in the Ferraris Mixer after maintenance.
5. Check that the environment where the machine is installed conforms to local regulations (a permit issued by the fire marshall
or by local autority may be necessary) and avoid dangerous concentration of paint cans around the equipment. It’s forbidden
to stock inflammable materials or other materials inside the machine. It’s forbidden to use free flames, incandescent objects or
equipments able to create sparks in the local where the machine is installed.
6. It is recommended to install a ventilation system to guarantee that the concentration of dangerous vapours around all
electrical components is less than 30%.
7. At the end of the work avoid keeping free cans inside the machine and avoid keeping the machine switched on if it isn’t used.
8. If the machine is switched on but it isn’t stirring inside it, there isn’t residual mechanical energy because the inverter is switched
off.
9. In the locations where the Mixer Ferraris is installed the prohibition symbols “no smoking” have to be present placed at 5 meters
from the machine.