Fast & Fluid Ferraris Automatic Mixer - Manual (Page 31)

FAST & FLUID MANAGEMENT srl
A Unit of Idex Corporation
1155432A-it,en,de.doc – 11/09/2006 31
SPEED CHECK (With working machine).
• Insert an empty can with a high superior to 230 mm. and close the door/shutter.
• Set the high mixing speed using the key
• Push the key start or or
• After the closing of the plates the machine indicates an error (E-7).
• The machine has automatically to start the cycle with a slow velocity
Cleaning
Outside parts of the door/shutter
Use a normal not abrasive product for the cleaning of the washable domestic surfaces.
Command panel , keyboard
Use a wet cloth with neutral soap and dry without rinsing with a dried cloth or absorbent paper.
Inside parts (frame).
If there are paint leakages, clean immediately !
If necessary take away the dried part using a paddle and then use a normal not abrasive product for the cleaning of washable
domestic surfaces.
Inside parts (turning basket group).
If there are paint leakages, clean immediately !
If necessary take away the dried part using a
paddle.
To clean the lubricated parts it will be sufficient
to use a cloth able to take away residual paint
parts and a little part of lubricant product.
Lubricate immediately following the procedures
below shown .
Accidental inside and/ or outside paint leakages
Clean immediately the machine and the floor in the “operator area” to avoid sliding
risks.
Empty the drainage tank unscrewing the cap indicated and picking up the paint in a
low container.
Drainage cap
Don’ t use water jet or polishing machine with high pressure to clean the mixer Ferraris!
Don’ t use solvent to clean mixer Ferraris!
If the use of solvent is necessary , keep the machine switched off with the door/shutter open for 1 hour before using it.