General maintenance, Gauge label replacement - model 53 pd – Fluid Management 53PD Blendorama User Manual User Manual
Page 31
Fluid Management Customer Service 1 . 800 . 462 . 2466
Blendorama Dispenser | 29
Before replacing the labels, calibrate the plungers as per the calibration instructions. Also make sure that the
replacement label is the correct one - check the part numbers.
a. Remove both black and red gauges.
b. Peel the labels off both the red and black
gauges. Remove all traces of adhesive (use a
solvent if necessary). Wipe dry.
c. Replace both gauges and set to the fully down
position. Lift the black (outer) gauge and engage
the locking pin in the 2nd hole from the top.
d. Mark a line on the black gauge, level with the top
of the red handle. Use a fine felt tip pen or pencil
(or scratch with a sharp object), then remove the
black gauge from the pump.
General Maintenance
Gauge label replacement - Model 53 PD