Hale HP Series - Manual (Page 10)

HP SERIES
PORTABLE PUMPS
USER OPERATION AND MAINTENANCE
10
EQUIPMENT SPECIFICATIONS
ENGINE:
MAKE: BRIGGS AND STRATTON VANGUARD™
MODEL: 350447 Series
TYPE: Horizontal Shaft, Air Cooled, V-Twin,
OHV
HORSEPOWER: 18 BHP (13.4 kW) at 4000 RPM
TORQUE: 40.7 N-m (30 ft-lb) Max. at 2600 RPM
BORE x STROKE: 72 x 77 mm (2.83 x 2.75 in)
DISPLACEMENT: 570 cc (34.75 cu in)
OIL CAPACITY: 1.4 liter (3.0 pint)
FUEL TANK: Cross linked Polyethylene
FUEL CAPACITY: 12 liters (3 gallons)
ELECTRICAL: 16 AMP Alternator
EMISSIONS: Meets 1994 California Air
Resources Board (CARB) Standards
The serial number of each pump
assembly is located on a tag attached
to the engine shroud near the recoil
starter pull handle. The following figure
shows the serial number tag.
PUMP IDENTIFICATION TAG
NOTICE
Performance of HP Series pumps
meets or exceeds NFPA1921
requirements. For complete NFPA1921
compliance, the pumping units must be
marked with specific labels. Consult
factory if these labels are required.
HALE PRODUCTS, INC
ease of discharge hose connection. The
unique valve permits the discharge to
be directed in any direction without
disturbing the position of the pump. The
valve is a self checking type that
automatically closes to form a positive
seal when priming the pump.
Each portable pump is provided with a
marine grade quick connect electrical
socket. This socket is used to power the
optional light mast for night time
operations. The same electrical socket
can also be used to connect a trickle
charger to ensure the battery is charged
and the pump is always in a ready state.
The HP series pump line has been
designed to meet stringent
requirements. The curves that follow are
the expected performance that can be
obtained from that specific pump
model. All the tests were conducted at
sea level.