Hale CAFSPro - Manual (Page 53)

Routine Maintenance ❑
53 CAFSPro User Operation Manual
p/n: 029-0020-75-0
7.2 OIL AND OIL FILTER
The air compressor oil and oil filter must be changed every 100 hours of
operation or when the apparatus engine oil is changed.
To Change Oil and Oil Filter
1. Locate the oil reservoir separator and air compressor oil filter on the
apparatus. (See Figure 7-1: ‘Maintenance Overview’ on page 1-52.)
Also see CAFSPro Installation Guide, p/n: 029-0020-78-0, Section 5
“System Oil Fill,” on page 47, for additional information.
2. Place a waste container below the drain valve to catch the oil or mois-
ture as it drains. The container must have sufficient capacity to hold the
drained oil, approximately 8 to 9 quarts (7.5 to 8.5 liters).
3. Remove the valve plug and OPEN the valve to drain all oil.
4. When all oil has drained from the system, CLOSE the valve and
REPLACE the valve plug.
5. Place the waste container under the oil filter and unscrew the filter from
its mount adapter. An oil filter strap-wrench might be necessary to
loosen the filter.
6. Drain remaining oil from the filter.
IMPORTANT !
DISPOSE OF THE WASTE WATER/OIL AND OIL FILTER IN ACCORDANCE
WITH YOUR LOCAL RECYCLING REGULATIONS.
7. Obtain a new Fram HP-6 oil filter (Hale p/n: 010-0650-01-0). Before
installing new filter, fill the filter approximately 1/2 full with SAE 15W-
40HD oil and lightly coat the filter gasket with SAE 15W-40HD oil.
Note: The oil filter (Hale p/n: 010-0650-01-0) is a Fram HP-6 model filter. The oil
filter must have a 200 PSI (14 BAR) pressure rating. DO NOT use a substitute
type or brand of filter without first checking for a 200 PSI (14 BAR) pressure rat-
ing. Also see CAUTION! on page 54.