Hale Q Series Muscle - Manual (Page 55)

55 MUSCLE (Midship) Pumps Installation, Operation, and Maintenance Manual
p/n: 029-0020-63-0
Basic Operation 
4. Exit the driving compartment only after all the preceding steps are completed and
you are sure the appropriate lights in the cab and panel are ON.
CAUTION!
DO NOT LEAVE THE CAB OR ATTEMPT TO PUMP UNTIL ALL GREEN PUMP LIGHTS IN
THE CAB ARE ON.
Figure 4-1: Driver’s Compartment Indicator Lights
CAUTION!
DO NOT OPEN THE THROTTLE UNLESS THE GREEN INDICATOR LIGHT IS ON. (SEE
FIGURE 4-2: “PUMP OPERATOR’S PANEL” ON PAGE 56.)
5. Verify that the pump panel GREEN shift indicator OK TO PUMP light illuminates
and that all hose connections are complete.
For “Split-Shaft” operation
 Place the truck transmission in the proper pump operating range or gear. For
most pumpers this is direct drive (1:1) ratio. In addition, the speedometer
should register after the shift has been completed.
 If the shift does not complete, shift the transmission back to NEUTRAL (N)
and repeat the entire procedure.