Manual transmission, Automatic transmission, Manual and automatic fax redial – Brother FAX 2600 User Manual
Page 61: Dual access
S E T U P S E N D
6 - 2
Manual Transmission
Manual transmission lets you hear the dial tone, ringing and fax receiving tones
before sending the fax.
1
Place the original face down in the ADF.
2
Pick up the handset and listen for a dial tone—OR—press
Hook
and listen for
a dial tone.
3
Enter the fax number you want to call (you can enter the digits using the dial
pad, or you can enter a One Touch or Speed Dial number or you can call using
Search). (See
4
When you hear the fax tone, press
Start
.
5
If you’re using the handset, hang up.
Automatic Transmission
This is the easiest way to send a fax. IMPORTANT: Do not pick up the
handset, or press
Hook
.
1
Place the original face down in the ADF.
2
Enter the fax number using One Touch, Speed Dial, Search or the dial pad.
(See
3
Press
Start
.
Manual and Automatic Fax Redial
If you’re sending a fax manually and the line is busy, after you disconnect the
call press
Redial/Pause
to retry the number.
If you’re sending a fax automatically and the line is busy, the FAX/MFC will
automatically redial up to three times at 5 minute intervals.
Dual Access
You can scan up to 50 originals into the fax memory, even while the FAX/MFC
is receiving or sending another fax (from memory). You can set temporary
settings for each fax you’re scanning, except Timer and Polling.
If you try to scan in and store a 51st fax, the FAX/MFC will send it immediately,
without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of a fax,
press
Stop
to cancel scanning. If you get a MEMORY FULL message while
scanning in a subsequent page, you'll have the option to press
Start
to transmit
the pages scanned so far, or to press
Stop
to cancel the operation.
1
Make sure the ADF is empty.
2
Place the original in the ADF.