Philips CDR800 - Manual (Page 29)

A-B editing (on CD changer only)
You can create a “track” by marking a passage of music
within one track on the current disc.This new “track” can
be used for recording or playing.The minimum track length
is 4 seconds.
Note:You can only make an A-B edit for a normal Audio
CD(RW).
1 Press A-B EDIT on the set.
➜ EDIT TRACK starts blinking, TRACK and the current track
number
? are displayed.
2 Rotate the ¡ EASY JOG ™ control until the desired track
number is displayed.
3 Press YES to confirm the selected track.
➜
FROM A = XX : XX and the track time will be displayed.
The first 4 seconds of the track will be played
continously.The initial position of marker A is always the
start of the chosen track.
0 To fast forward to the desired start position press
5 or 6
on the set.
0 To fine tune the position then rotate the
¡ EASY JOG ™
control.
4 Press YES or A-B EDIT to confirm the position of marker a.
➜
TO B = XX : XX and the new “track” time will be
displayed.The first 4 seconds before marker position B
until marker position B will be played continously.The
initial position of marker B is always the position of
marker A plus 4 seconds.
0
To fast forward to the desired stop position press 5 or 6
on the set.
0
To fine tune the position rotate the ¡ EASY JOG ™
control.
5 Press YES or A-B EDIT to confirm the marked passage.
➜ EDIT TRACK is shown,
A-B and the track edit time are
displayed.
➜ The new “track” will be stored.
0
Press PLAY/PAUSE 2/; to play the ”track”.
0 Press RECORD to record the ”track” (also see
”Recording”).
Note: A-B EDIT can also be pressed during play.The Track Edit
procedure will then start from the position where A-B EDIT was
pressed.
Clearing the A-B edit
1 Press NO during stop.
➜
CLEAR A-B ? is displayed.
2 Press YES to clear the markers.
➜ The markers A-B are cleared.
Note: If you open the CD changer tray the A-B edit is deleted.
Special features
26
English
xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 26