Philips CDR800 - Manual (Page 15)

Analog connections
These connections are required for playback and recording via
an amplifier/receiver, equipped with an analog in- and outputs.
1 Connect supplied audio cord between the ANALOG
OUT-jacks on the set and the ANALOG input jacks of the
amplifier/receiver (TAPE IN, CD-R, AUX or PLAY IN).
Insert the red plugs into the R jacks, and the white plugs
into the L jacks.
2 Connect supplied audio cord between the ANALOG IN-
jacks on the set and the analog outputs of the
amplifier/receiver (CDR OUT,TAPE OUT, AUX OUT, REC
OUT etc.).
Insert the red plugs into the R jacks, and the white plugs
into the L jacks.
3 Connect all other components of your system (tape deck,
CD player, tuner, record player etc.) via their ANALOG
OUT-jacks to the appropriate analog input jacks of the
amplifier/receiver (CD IN,TUNER IN, AUX IN, PHONO
IN etc.).
➜ Any analog device, connected to the amplifier/receiver
can now be used as recording source (
AUX ANALOG).
Digital connections
Direct digital coaxial connection
This connection is required for direct recording from a digital
coaxial source (e.g a CD player, DVD, DAT).
1 Connect a digital coaxial cord between the DIGITAL IN-
jack on the set and the DIGITAL OUT jack of the digital
source.
➜ Recording can now be done via the digital coaxial input
(
AUX DIGITAL).
Direct digital optical connection
This connection is required for direct recording from a digital
optical source (e.g. a CD player, DVD, DAT).
1 Remove the dust caps from the digital optical connections
of both source and CD recorder. Keep the caps in a safe
place.
2 Connect an optical fibre-optic cord
between the OPTICAL IN jack of
the set and the OPTICAL OUT jack
of the source.
Make sure you insert both plugs
fully, until a click is heard.
➜ Recording can now be done via the digital optical input
(
AUX OPTICAL).
CD RECORDER
CD PLAYER
2
CD RECORDER
1
CD PLAYER
2
CD RECORDER
AMPLIFIER/
RECEIVER
CD PLAYER
1
RECORD PLAYER
3
3
Installation
12
English
xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 12