Philips CDR800 - Manual (Page 16)

Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
1 Connect a digital coaxial cord between the DIGITAL IN-
and OUT jacks on the set and e.g. the (digital) AUX in- and
output jacks on the digital receiver.
➜ Any digital device, connected to the digital input jacks of
the digital receiver (e.g. CD and DVD) can now be used
as recording source.
Power supply
The type plate is located on the rear of the set.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
not, consult your dealer or service organisation.
2 Make sure all connections have been made before
switching on the AC power supply.
3 Connect the power cord supplied to AC MAINS ~ and to
the wall outlet.This switches on the AC power supply.
4 Press POWER to switch on the set.
➜
WELCOME TO PHILIPS AUDIO will be displayed.
0
Press POWER again to switch off the set.
When the set is switched off, it is still consuming some
power.To disconnect the set from the power completely,
remove the power plug from the wall outlet.
Demo mode
The demo mode displays various features of the set and
will start automatically when no key has been pressed for
several minutes or during Standby mode.
To cancel demo mode
0
Keep STOP 9 on the set pressed for at least 5 seconds.
➜ The demo mode is cancelled permanently.
3
CD RECORDER
1
DIGITAL
RECEIVER
1
CD RECORDER
Installation
13
English
xp CDR 800/17.1 eng. 25-07-2001 15:12 Pagina 13