Black Box 16 port - Manual (Page 219)

Black Box Console Server user guide 219
Writing to FLASH memory
The Console Server will load the software into RAM, perform checks, and then write
the software into FLASH memory. The writing to FLASH will take a few minutes and
during this time the unit will not respond to user input. While the new software is being
loaded into FLASH memory, the power and network LEDs on the front of the unit
display a pattern.
WARNING do not turn the power off/on while the unit is writing to FLASH memory
pattern of
Console
Server LEDs
during load
of software
into FLASH
This pattern is repeated approximately once per second.
The Network LED flickers green if network traffic is identified on the network ports.
The pattern on each LED is repeated approximately once per second.
reboot When the software has finished downloading you must reboot the unit. To do this, type
the command:
reboot