Barco R9001490 - Manual (Page 28)

4-3
Connections
5976072 BARCOELM R12 05052000
WD9@PDIQVU
9,'(2 69,'(2 R G B H / C V
On
98 2 7 9 1 0 R G B H / C V
On
High Bandwidth RGB ANALOG INPUT
R G B H / C V
On
High Bandwidth 5 CABLE INPUT
OUT IN
On
9 8 4 0110
T9DÃ9DBDU6GÃDIQVU
OUT IN
On
9 8 4 0110
T9DÃ9DBDU6GÃDIQVU
COMM PORT TRIGGER OUT RS232/422 OUT RS232/422 IN
IR-Rec eiver Diagnosti c Code Green Operati on
Red Stand-by
IR Sync OK Har dwi red
remote
CTRL 1
Hardwi red
remote
CTRL 2 Two way
hardwired
remote
CTRL 3
fixed inputs 1 & 2
RGB Analog input
5 Cable input
varialable inputs
2 analogue inputs 3 & 4
Choice out of :
Video, S-video input order no. : R9827900
RGBS/RGsB analog input order no. : R9827910
RGB3S/RG3sB input order no. : R9827920
Component Video order no. : R9827930
The sequence of insertion has no importance. Duplicated inputs can be used.
2 digital inputs 5 & 6
Choice out of :
SDI input order no. : R9840110
HD SDI Digital input order no. : R9840450
Input facilities, RCVDS05 or VS05 connected.
Note : When using a RCVDS05 or VS05, the input configuration of the projector must be as follows:
Slot 1 : not used
Slot 2 : RGB and Component video input
Slot 3 : Video input module
Slot 4 : not used
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module has to be
connected to slot 2 of the projector.
To switch the projector in the 5-cable mode see chapter 'Installation mode'.
Input Source Connection
Input facilities