Barco R9001490 - Manual (Page 26)

4-1
Connections
5976072 BARCOELM R12 05052000
4
W D 9@P D IQ VU
9,'(2 6 9,'(2 R G B H / C V On 98 27910 R G B H / C V O n
H i g h Bandwidth R GB ANA LO G INP UT
R G B H / C V On
Hig h Bandwi d th 5 C ABLE IN PUT
OUT IN On 984011 0
T 9DÃ 9DBDU 6 GÃ DIQ VU
O UT IN On 984011 0
T 9DÃ 9DBDU 6 GÃ DIQ VU C OM M PO R T TR IGG E R O UT RS23 2/4 22 O UT RS23 2/4 22 IN
I R- Re cei ver D ia g n ost ic C od e G re en Op era tio n
R ed St and -b y
I R Sy nc OK H ar dwi re d r em ot e C TR L 1
H ard wir ed re mo te C TR L 2 Tw o wa y ha rdw i re d re mo te C TR L 3
COLOR PHASE SHARPN TINT BRI GHTN
ST ANDBY ENTER T EXT
EXIT
PAUSE
&2175 $67
- +
- +
- +
- +
- + 0 9
7 8
6 5
4 3
2 1
( 17(5
32a
3$86(
- +
3+$6(
)5((= 7( ;7
(;,7 $'-
67%<
6+$531 (66
7,17
&2/25
%5,* +71(66
&2175$67
+( /3
?
COLOR PHASE
SHARPN TINT BRIGHTN
STANDBY
ENTER
TEXT
EXIT
PAUSE
&2175$67
$
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Switching ON
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
CONNECTIONS
Power Connection to Projector
AC Power (mains) cord connection
Use the supplied power cord to connect the projector to the wall outlet. Plug the female power connector (IEC309 2p+G 32A/250V
plug) into the blue male connector on the side of the projector.
The power input is auto-ranging from 230 VAC.
Needed power connection : 18 A.
230V/20A
50/60Hz