Initial fcoe and cee configuration, In this chapter, Overview – Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 User Manual
Page 53: End to end fcoe using fc isls, Chapter 5, Chapter 5, “initial fcoe and cee configuration

Converged Enhanced Ethernet Administrator’s Guide
31
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
Chapter
5
Initial FCoE and CEE Configuration
In this chapter
•
•
•
•
•
•
•
•
•
•
Overview
This chapter describes how to configure Fibre Channel over Ethernet (FCoE) and Converged
Enhanced Ethernet (CEE) properties on the switch using CLI commands. For detailed information
about all the CEE CLI commands, refer to the Converged Enhanced Ethernet Command Reference
Supporting Fabric OS v6.4.0 (53-1001762-01).
All of the CLI commands are entered using the Telnet or console interface on the Brocade FCoE
hardware.
End to End FCoE using FC ISLs
Support for end-to-end FCoE is achieved through FC ISLs, allowing FCoE traffic to be carried across
multiple FC ISL hops, eventually terminating in FC or FCoE storage.