Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 39)

Converged Enhanced Ethernet Administrator’s Guide 17
53-1002163-02
CEE Command Line Interface
2
DRAFT: BROCADE CONFIDENTIAL
NOTE
Pressing Ctrl+Z or entering the end command in any mode returns you to privileged EXEC mode.
Entering exit in any mode returns you to the previous mode.
CEE CLI keyboard shortcuts
Table 5 lists CEE CLI keyboard shortcuts.
Feature
configuration CEE map:
switch(config-ceemap)#
Standard ACL:
switch(conf-macl-std)#
Extended ACL:
switch(conf-macl-ext)#
From the global configuration mode,
specify a CEE feature by entering
one of the following commands:
•
cee-map
•
mac access-list
Access and configure CEE features.
Identify traffic based on the MAC
addresses, such as VLAN IDs and
different encapsulations.
Standard Access Control Lists filter
the traffic on a source address and
block traffic close to a destination.
Extended Access Control Lists block
traffic based on any given packet
attribute.
Console and
VTY (line)
configuration switch(config-line)# From the global configuration mode,
configure a terminal connected
through the console port by entering
the line console command.
Configure a terminal connected
through a Telnet session by entering
the line vty command. Configure a terminal connected
through the console port or a
terminal connected through a Telnet
session.
After you apply the access list to an
interface, a Virtual Teletype (VTY), or
through a command using the
access list keyword, it becomes
effective.
TABLE 4 CEE CLI command modes (Continued)
Command
mode Prompt How to access the command mode Description
TABLE 5 CEE CLI keyboard shortcuts
Keystroke Description
Ctrl+B or the left arrow key Moves the cursor back one character.
Ctrl+F or the right arrow key Moves the cursor forward one character.
Ctrl+A Moves the cursor to the beginning of the command line.
Ctrl+E Moves the cursor to the end of the command line.
Esc B Moves the cursor back one word.
Esc F Moves the cursor forward one word.
Ctrl+Z Returns to privileged EXEC mode.
Ctrl+P or the up arrow key Displays commands in the history buffer with the most recent command
displayed first.
Ctrl+N or the down arrow key Displays commands in the history buffer with the most recent command
displayed last.