Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 154)

132 Converged Enhanced Ethernet Administrator’s Guide
53-1002163-02
RMON configuration and management
14
DRAFT: BROCADE CONFIDENTIAL
• Broadcast packets
• Multicast packets
• CRC errors
To collect RMON group statistics on an interface and enable collection history, perform the
following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
switch#configure terminal
2. Enter the interface command to specify the CEE interface type and slot/port number.
switch(config)#interface tengigabitethernet 0/1
3. Enable the CEE interface.
switch(conf-if-te-0/1)#no shutdown
4. Configure RMON group statistics on the interface.
switch(conf-if-te-0/1)#rmon collection stats 200 owner john_smith
5. Enter the copy command to save the running-config file to the startup-config file.
switch(conf-if-te-0/1)#do copy running-config startup-config
Configuring RMON settings
To configure RMON alarms and events, perform the following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
switch#configure terminal
2. Configure the RMON alarms.
Example of an alarm that tests every sample for a rising threshold
switch(config)#rmon alarm 1 1.3.6.1.2.1.16.1.1.1.5.65535 interval 10 absolute
rising-threshold 10 event 1 falling-threshold 10 event 20 owner john_smith
Example of an alarm that tests the delta between samples for a falling threshold
switch(config)#rmon alarm 5 1.3.6.1.2.1.16.1.1.1.5.65535 interval 10 delta
falling-threshold 65 event 42 owner john_smith
3. Enter the copy command to save the running-config file to the startup-config file.
switch(config)#do copy running-config startup-config
Configuring RMON events
You can add or remove an event in the RMON event table that is associated with a RMON alarm
number.
To configure RMON events, perform the following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
switch#configure terminal