Brocade Communications Systems Converged Enhanced Ethernet 53-1002163-02 - Manual (Page 144)

122 Converged Enhanced Ethernet Administrator’s Guide
53-1002163-02
CEE map configuration
11
DRAFT: BROCADE CONFIDENTIAL
Applying a CEE provisioning map to an interface
To apply a CEE provisioning map, perform the following steps from privileged EXEC mode.
1. Enter global configuration mode.
switch#configure terminal
2. Specify the 10-gigabit Ethernet interface. In this example, 0/2 is used.
switch(config)#interface tengigabitethernet 0/2
3. Apply the CEE map on the interface.
switch(conf-if-te-0/2)#cee default
4. Enter the copy command to save the running-config file to the startup-config file.
switch(config)#do copy running-config startup-config
Verifying the CEE maps
To verify the CEE map, perform the following steps from privileged EXEC mode.
1. Enter global configuration mode.
switch#configure terminal
2. Verify the CEE map provisioning for a specified name.
switch(config)#do show cee maps name